saskatoon
Saturn Player
Joined: January 2013
Posts: 111
Location:
|
Post by saskatoon on Jan 15, 2022 14:01:39 GMT
The best way to set the laser seems to be by reading the voltage to properly set the resistance, as shown in this video: www.youtube.com/watch?v=jLogV-dlGh4This is being done on a Model 1 board. I am curious if anybody knows which pin is the RF pin on a Model 2 JVC board. There is a point labeled ARF but I am not certain if that is the right point. Any assistance would be appreciated.
|
|
|
Post by zyrobs on Jan 15, 2022 14:16:00 GMT
I did not test it but isn't there a pin marked RFO on the underside in the top right corner?
edit: in the earlier 21pin drives it is labelled ARF, on the later one it is RFO, but it's the same pin. I'd try measuring that.
|
|
saskatoon
Saturn Player
Joined: January 2013
Posts: 111
Location:
|
Post by saskatoon on Jan 19, 2022 23:41:39 GMT
Beauty, I found some old leads to cannibalize and I wanted to try this.
I will report back when I finally get a unit on my bench.
|
|